If the printer has been powered on, the fuser may be hot. Push the two retaining levers 2 towards the rear of the printer to lock the fuser in place. The rendering intents that the printer driver provides are listed below: The window which opens when you click Properties depends on which printer driver has been installed. If necessary, use the SDM Printer Discovery window to find all available printers on your network or connected to your computer.
|Date Added:||18 October 2012|
|File Size:||7.25 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The first prints on just the oki c5450 page, and oki c5450 second prints on any or all subsequent pages. Where items in the printer driver are the same as those in the operator panel menus, and you print documents from Windows, the settings in okk Windows printer driver will override those oki c5450 in the operator panel menus. Page 62 Monitor k Optimised for printing graphics from applications such as Microsoft Office.
Normal setting is 0. Monitor k Vivid Optimised for printing photographs, but with even more saturated colours than the Monitor k Perceptual setting.
Switch the printer on and wait oki c5450 it to warm up about 1 minute. Page Lower the new belt unit into place, with the lifting bar at the front and the drive gear towards the rear of the printer.
Oki C5450 User Manual
The project window will display one. Lift the right-hand end of the oki c5450 and then draw the cartridge to the right to release the left-hand end as shown, and withdraw the toner cartridge out of the printer. If the printer has been powered on, the fuser may be hot. If this function is not enabled, oki c5450 printer will stop oki c5450 request the correct size of paper to be loaded. Your results will vary depending on the subject and the conditions under which the photograph was taken.
Page Lift each of the image drum units out of the printer and place them in a safe place away from direct sources of heat and light.
Page 15 Load letter headed paper face down and top edge towards the front of the printer, as shown. Page 52 PostScript driver This driver must be adjusted for any upgrade oki c5450 installed.
Identify the fuser handle 1 on the top of the fuser unit. Lower the top cover but do not press oki c5450 to latch it closed oki c5450. Page Lift the front cover release and pull open the front cover. For general use the automatic settings will suffice, providing reasonable default settings that will produce good results for most documents. When printing double sided pages duplex unit required.
Place it safely to one side. If the colours look too dull, try the Monitor k Vivid or Digital Camera oki c5450.
Oki , Image Drum Unit Magenta, C, C, C, C Original
Page Starting with the cyan image drum unit okki the fuser, replace the four image drums into the drum cavity, making sure to locate them in the correct order. Holding it by its top centre, lift the cyan image drum, complete with its toner cartridge, up and out of the printer.
Tries to print white as it appears on screen. The green image drum surface at the base of each cartridge is very delicate and light sensitive. To print the manual oki c5450, please, download it. In the Define Overlays window, enter the name a and ID b of the required overlay, and define which page s c of your documents will use this overlay.
In PostScript Emulation mode the job will be cancelled if timeout occurs. Switch oki c5450 the printer and allow the fuser to cool for about 10 minutes before opening the cover. oki c5450
Oki C – ComputerFood
The Filter Printer D5450 dialogue box appears. Pull the two fuser retaining levers 2 towards the front of the printer so that they are fully upright.
This will lock the cartridge into place and release toner into the image drum unit. Page toner cartridge oki c5450 this time unless oki c5450 remaining toner level is very low. The most up-to-date drivers and manuals are available from the Oki Europe website: